Setting a Dead Timer for the Neighboring Routers
■
Configuring an Interval Required for Sending LSU Packets
■
Setting an Interval for LSA Retransmission between Neighboring Routers
■
Setting a Shortest Path First (SPF) Calculation Interval for OSPF
■
Configuring STUB Area of OSPF
■
Configuring the NSSA of OSPF
■
Configuring the Route Summarization of OSPF Area
■
Configuring Summarization of Imported Routes by OSPF
■
Configuring OSPF Virtual Link
■
Configuring the OSPF Area to Support Packet Authentication
■
Configuring OSPF Packet Authentication
■
Configuring OSPF to Import Routes of Other Protocols
■
Configuring Parameters for OSPF to Import External routes
■
Configuring OSPF to Import the Default Route
■
Setting OSPF Route Preference
■
Configuring OSPF Route Filtering
■
Configuring the Filling of the MTU Field When an Interface Transmits DD
■
Packets
Disabling the Interface to Send OSPF Packets
■
Configuring OSPF and Network Management System (NMS)
■
Resetting the OSPF Process
■
Enabling OSPF and Entering OSPF View
Perform the following configurations in System View.
Table 131 Enabling the OSPF process
Operation
Enable the OSPF process
Disable the OSPF process
By default, OSPF is not enabled.
When enabling OSPF, note the following:
By default, the OSPF process ID is 1.
■
If a router is running multiple OSPF processes, 3Com recommends that you to
■
use
in the command to specify different Router IDs for different
router-id
processes.
Command
process_id
ospf [
[ router-id
undo ospf [
process_id
OSPF Configuration
router_id
] ]
]
133