3Com SuperStack 4 Configuration Manual page 318

330 C 12: F S
HAPTER ILE
Sending the Information
to Loghost
M
YSTEM ANAGEMENT
Table 387 Sending the Information to SNMP
Device Configuration
Enable info-center
Set the information output
direction to SNMP
Set information source
Switch
Configuring SNMP features -
Network The same as the SNMP
management configuration of the Switch
workstation
7 Turn on/off the information synchronization Switch in Fabric
Figure 83 Turn on/off the Information Synchronization Switch in Fabric
Device Configuration
Enable info-center
Switch
Set the information
output direction to
SNMP
To send information to the loghost, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 388 Enable/Disable Info-Center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to loghost
Perform the following operation in System View.
Default value
By default,
info-center is
enabled.
-
-
-
Default Value
By default, info-center is
enabled.
By default, Switches of master
log in Fabric, debugging and trap
information synchronization are
turned on, so as log and strap
information synchronization
Switches in other Switches.
Command
info-center enable
undo info-center enable
Configuration description
Other configurations are valid
only if the info-center is
enabled.
-
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the Switch of the
corresponding module before
defining output debugging
information.
See SNMP Configuration
-
Configuration
Description
Other configurations are
valid only if the
info-center is enabled.
This configuration can
keep log information,
debugging information
and trap information in
Fabric in every Switch
synchronized.