3Com SuperStack 4 Configuration Manual page 310

322 C 12: F S
HAPTER ILE YSTEM
Executing Test
Displaying Test
Information
M
ANAGEMENT
regard the destination unreachable. The parameter discussed in this subsection is
equal to the parameter
Perform the following configurations in HWPing Test Group View.
Table 376 Configure a Test Timeout Time
Operation
Configure a test timeout time
Restore the default setting of test timeout
time
By default, test timeout time is set to three seconds.
After creating a test group and configuring the required test parameters, you can
perform an HWPing test in the test group by executing the
command.
Perform the following configuration in HWPing Test Group View.
Table 377 Test
Operation
Execute test
After you execute the
test result. You may view the test result information by executing the
command.
hwping
You may view the test history and the last test information respectively by
executing
display hwping history
Perform the following operations in any view.
Table 378 Display the Test Information
Operation
Display the test information display hwping { history | result }
in a command, except in a different time unit.
-t ping
Command
timeout
undo timeout
Command
test-enable
command, the system does not display the
test-enable
and
display hwping result
Command
administer-name operation-tag
[
time
test-enable
display
commands.
]