3Com SuperStack 4 Configuration Manual page 313

If changed to boot format, it represents the milliseconds from system booting.
Generally, the data are so large that two 32 bits integers are used, and separated
with a dot '.'.
For example:
<189>0.166970 SW5500 IFNET/6/UPDOWN:Line protocol on interface
Ethernet1/0/2, changed state to UP
It means that 166970ms (0*2^32+166970) has passed from system booting.
If changed to
none
information.
There is a blank between timestamp and sysname. If the timestamp is
format, there is a blank between priority and sysname.
3 Sysname
The sysname is the host name, the default value is "
You can change the host name through
There is a blank between sysname and module name.
4 Module name
The module name is the name of module which created this logging information,
the following sheet lists some examples:
Table 379 Module Names in Logging Information
Module name
8021X
ACL
AM
ARP
CFAX
CFG
CFM
CMD
COMMONSY
DEV
DHCC
DHCP
DRV
DRV_MNT
ESP
ETH
FIB
FTM
FTMCMD
FTPS
HA
HTTPD
format, the timestamp field is not present in logging
sysname
Description
802.1X module
Access control list module
Access management module
Address resolution protocol module
Configuration proxy module
Configuration management platform module
Configuration file management module
Command line module
Common system MIB module
Device management module
DHCP Client module
Dynamic host configuration protocol module
Driver module
Driver maintenance module
End-station polling module
Ethernet module
Forwarding module
Fabric topology management module
Fabric topology management command line
module
FTP server module
High availability module
HTTP server module
Logging Function
none
".
SW5500
command.
325