3Com SuperStack 4 Configuration Manual page 297

Displaying MAC Address
Table
MAC Address Table
Management Display
Example
Table 354 Set the Max Count of MAC Address Learned by a Port
Operation
Set the Max Count of MAC Address
Learned by a Port
Restore the default Max Count of MAC
Address Learned by a Port
By default, there is no limit to the MAC addresses learned via the Ethernet port.
After the above configuration, execute the
display the running of the MAC address table configuration, and to verify the
effect of the configuration.
Execute the
debugging
configuration.
Table 355 Display and Debug MAC Address Table
Operation
Display the information in the
address table
Display the aging time of dynamic
address table entries
Networking requirements
The user logs into the switch via the Console port to display the MAC address
table. Switch display the entire MAC address table of the the switch. If this switch
is a member of a stack then the entire database of all the switches will be shown
here.
MAC Address Table Management
Command
mac-address max-mac-count
undo mac-address max-mac-count
display
command in User View to debug MAC address table
Command
display mac-address [
vlan-id
] | [ static | dynamic | blackhole
] [ interface {
interface-type interface-num
vlan-id ] [ count ] ]
display mac-address aging-time
count
command in all views to
mac-addr
[ vlan
interface-name
|
} ] [ vlan
309