3Com SuperStack 4 Configuration Manual page 317

Table 384 Sending the Information to Monitor Terminal
Device Configuration
Enable info-center
Set the information
output direction to
monitor
Set information
Switch
source
Enable the terminal
display function and
this function for the
corresponding
information
4 Sending the Information to log buffer.
Table 385 Sending the Information to Log Buffer
Device Configuration
Enable info-center
Set the information output
direction to logbuffer
Switch Set information source
5 Sending the Information to trap buffer.
Table 386 Sending the Information to Trap Buffer
Device Configuration
Enable info-center
Set the information
output direction to
trapbuffer
Switch Set information source
6 Sending the Information to SNMP
Default Value Configuration Description
By default, Other configurations are valid only if
info-center is the info-center is enabled.
enabled.
- -
- You can define which modules and
information to be sent out and the
time-stamp format of information, and
so on. You must turn on the Switch of
the corresponding module before
defining output debugging
information.
- For Telnet terminal and dumb terminal,
to view the information, you must
enable the current terminal display
function using the terminal
monitor command.
Default Value Configuration Description
By default, Other configurations are valid
info-center is only if the info-center is enabled.
enabled.
- You can configure the size of the
log buffer at the same time.
- You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the Switch of the
corresponding module before
defining output debugging
information.
Default Value Configuration Description
By default, info-center Other configurations are valid
is enabled. only if the info-center is enabled.
You can configure the size of
the trap buffer at the same time.
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the Switch of the
corresponding module before
defining output debugging
information.
Logging Function 329