3Com SuperStack 4 Configuration Manual page 328

340 C 12: F S
HAPTER ILE
Configuration Examples
of Sending Log to Unix
Loghost
M
YSTEM ANAGEMENT
The Switch provides a command to turn on/off the synchronization Switch in every
Switch. If the synchronization Switch of a Switch is turned off, it does not send
information to other Switches but still receives information from others.
1 Enable info-center
Perform the following operation in System View.
Table 413 Enable/Disable Info-center
Operation
Enable info-center
Disable info-center
2 Turn on the information synchronization Switch
Perform the following operation in System View.
Table 414 Turn on/off the Information Synchronization Switch of every Switch
Operation
Turn on the information
synchronization Switch of the
specified Switch
Turn off the information
synchronization Switch of the
specified Switch
You can turn on/off the synchronization Switch of the specified information on the
specified Switch as needed.
Displaying and Debugging Info-center
After the above configuration, performing the
can view the running state of the info-center. You can also authenticate the effect
of the configuration by viewing displayed information. By performing the
command in User View, you can clear the statistics of info-center.
Perform the following operation in User View. The
performed in any view.
Figure 85 Displaying and Debugging Info-center
Operation
Display the content of information
channel
Display configuration of system log and
memory buffer
Clear information in memory buffer
Clear information in trap buffer
Networking Requirement
The networking requirements are as follows:
Sending the log information of the Switch to Unix loghost
■
The IP address of the loghost is 202.38.1.10
■
Command
info-center enable
undo info-center enable
Command
info-center switch-on {
master | all } [ debugging | logging
| trapping ]*
undo info-center switch-on {
| master | all } [ debugging |
logging | trapping ]*
Command
display channel [
channel-name
display info-center
reset logbuffer
reset trapbuffer
unit-id
unit-id
command in any view, you
display
command still can be
display
channel-number
]
|
reset
|