Troubleshooting RIP
Networking Diagram
Figure 31 RIP configuration networking
Ethernet
SwitchC
Network address:
117.102.0.0/16
Configuration Procedure
The following configuration only shows the operations related to RIP. Before
performing the following configuration, please make sure the Ethernet link layer
can work normally.
1 Configure RIP on Switch A
[Switch A]rip
[Switch A-rip]network 110.11.2.0
[Switch A-rip]network 155.10.1.0
2 Configure RIP on Switch B
[Switch B]rip
[Switch B-rip]network 196.38.165.0
[Switch B-rip]network 110.11.2.0
3 Configure RIP on Switch C
[Switch C]rip
[Switch C-rip]network 117.102.0.0
[Switch C-rip]network 110.11.2.0
The Switch 5500G-EI cannot receive the update packets when the physical
connection to the peer routing device is normal.
RIP does not operate on the corresponding interface (for example, the
■
command is executed) or this interface is not enabled through the
rip work
command.
network
The peer routing device is configured to be in the multicast mode (for example,
■
the
rip version 2 multicast
has not been configured on the corresponding interface of the local Ethernet
Switch.
Interface address:
155.10.1.1/24
Interface address:
110.11.2.1/24
Interface address:
Interface address:
117.102.0.1/16
196.38.165.1/24
command is executed) but the multicast mode
Network address:
155.10.1.0/24
SwitchA
Network address:
110.11.2.2/24
SwitchB
Network address:
196.38.165.0/24
RIP
129
undo