Table of Contents
Advertisement
Supported configurations on PowerEdge R230
systems
NOTE:
Your system supports internal, hot swappable hard drives and cabled hard drives.
Table 1. Supported configurations on PowerEdge R230 systems
PowerEdge R230 Systems
Two hard drive systems
Four hard drive systems
Front panel features and indicators
Figure 2. Front panel features and indicators — four 3.5-inch or 2.5-inch hot swappable hard drive chassis
Table 2. Front panel features and indicators — four 3.5-inch or 2.5-inch hot swappable hard drive chassis
Item
Indicator, button, or connector
1
Power-on indicator, power
button
2
NMI button
3
System identification button
10
About the PowerEdge R230 systems
Configurations
Up to two 3.5-inch cabled hard drives with non-redundant cabled power supply unit (PSU)
Up to four 3.5- inch cabled hard drives with non-redundant cabled PSU
Up to four 2.5-inch hot swappable hard drives in 3.5-inch hard drive adapters, with non-redundant
cabled PSU
Up to four 3.5-inch hot swappable hard drives with non-redundant cabled PSU
Icon
Description
Enables you to know the power status of the system. The power-
on indicator glows when the system power is on. The power button
controls the power supply output to the system.
NOTE:
On ACPI-compliant operating systems, turning off
the system using the power button causes the system to
perform a graceful shutdown before power to the system
is turned off.
Enables you to troubleshoot software and device driver errors when
running certain operating systems. This button can be pressed by
using the end of a paper clip.
Use this button only if directed to do so by qualified support
personnel or by the operating system's documentation.
Enables you to locate a particular system within a rack. The
identification buttons are on the front and back panels. When one
of these buttons is pressed, the LCD panel on the front and the
Advertisement
Table of Contents
Troubleshooting
