Examples of IEEE 802.1Q Encapsulation Configuration
Defining the VLAN Encapsulation Format
Command
Step 1
interface fastethernet
port.subinterface-number
Step 2
encapsulation dot1q vlan-identifier
Configuring NetWare on the Subinterface
Command
ipx network network
Examples of IEEE 802.1Q Encapsulation
Configuration
Cisco 1710 Security Router Software Configuration Guide
4-6
Chapter 4
To define the encapsulation format as IEEE 802.1Q, use the following commands
in interface configuration mode:
After you enable NetWare globally and define the VLAN encapsulation format,
you may need to enable the subinterface by specifying the NetWare network
number. Use this command in interface configuration mode:
This section provides configuration examples for each of the protocols described
in this chapter. The section provides the examples for the following:
Configuring AppleTalk over IEEE 802.1Q
•
•
Configuring IP Routing over IEEE 802.1Q
•
Configuring IPX Routing over IEEE 802.1Q
Configuring Routing Between VLANs with IEEE 802.1Q Encapsulation
Purpose
Specifies the subinterface on which IEEE 802.1Q
will be used.
Defines the encapsulation format as IEEE 802.1Q
and specifies the VLAN identifier.
Purpose
Specifies the IPX network number.
78-12696-01