Configuring Ip Multicast Group Addresses - Cisco 220 Series Smart Plus Administration Manual

Multicast Forwarding

Configuring IP Multicast Group Addresses

STEP 3
Configuring IP Multicast Group Addresses
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
• MLD Snooping—Check Enable to globally enable MLD Snooping on the
switch, or uncheck to disable it. By default, MLD Snooping is disabled.
• Unknown Multicast Action—Choose how to deal with unknown Multicast
frames. The possible options are:
Drop
- —Drops unknown Multicast frames.
Flood
- —Floods unknown Multicast frames.
Forward to Router Port
-
port.
Click Apply. The Multicast properties are defined, and the Running Configuration is
updated.
Use the IP Multicast Group Address page to query and add IP Multicast groups.
To define and view IP Multicast groups:
Click Multicast > IP Multicast Group Address.
The IP Multicast Group Address page displays all IP Multicast group addresses
configured by users.
Enter the parameters required for filtering.
• VLAN ID equals to—Define the VLAN ID of the group to be displayed.
• IP Version equals to—Select IPv6 or IPv4.
• IP Multicast Group Address equals to—Define the IP address of the
Multicast group to be displayed.
Click Go. The results are displayed in the IP Multicast Group Address table.
Click Add to add a static IP Multicast group address.
Enter the following information:
• VLAN ID—Select the VLAN ID of the group to be added.
• IP Version—Select either Version 4 or Version 6.
—Forwards unknown Multicast frames to mrouter
14
161