Removal Procedures; Left Side Removals; Left Cover Removal - Lexmark MB2338 Service Manual

Removal procedures

Keep the following tips in mind as you replace parts:
•
Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
•
Remove the toner cartridges, imaging kit, and trays before removing other printer parts. The imaging kit
must be carefully set on a clean, smooth, and flat surface. It should also be protected from light while out
of the device.
•
Disconnect all external cables from the printer to prevent possible damage during service.
•
Unless otherwise stated, reinstall the parts in reverse order of removal.
•
When reinstalling a part held with several screws, start all screws before the final tightening.
•
For printers that have a soft power switch, make sure to unplug the power cord after powering off.

Left side removals

Left cover removal

1
Remove the screw (A).
2
Open the front door.
3
Release the two latches (B), and then disengage the middle front part (C) of the cover from the front door.
Warning—Potential Damage: The ADF might swing open while you position the printer on its side.
A
Parts removal
209
7017-2xx, -4xx, -6xx