Removal Procedures - Lexmark MB790MFP Service Manual

Removal procedures

Before starting service work
Remove the power cord from the electrical outlet before you connect or disconnect any cable
or electronic board or assembly.
While performing service around the fuser assembly, ensure the fuser area has cooled down.
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly
to avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Note: A wide variety of screws are used; make note of their positions during service.
CAUTION:
CAUTION:
7462
4-5
Repair information
Previous
Next
Go Back