Dhcp Test - H3C S5600 SERIES Operation Manual

Hide thumbs Also See for S5600 SERIES:

Table of Contents

For detailed output description, see the corresponding command manual.

DHCP Test

Network requirements

Both the HWPing client and the DHCP server are H3C S5600 series Ethernet switches. Perform a

HWPing DHCP test between the two switches to test the time required for the HWPing client to obtain

an IP address from the DHCP server.

Network diagram

Figure 1-3 Network diagram for the DHCP test

Configuration procedure

Configure DHCP Server(Switch B):

Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to the DHCP part

of the manual.

Configure HWPing Client (Switch A):

# Enable the HWPing client.

<Sysname> system-view

[Sysname] hwping-agent enable

# Create a HWPing test group, setting the administrator name to administrator and test tag to DHCP.

[Sysname] Hwping administrator dhcp

# Configure the test type as dhcp.

[Sysname-hwping-administrator-dhcp] test-type dhcp

# Configure the source interface, which must be a VLAN interface. Make sure the DHCP server resides

on the network connected to this interface.

[Sysname-hwping-administrator-dhcp] source-interface Vlan-interface 1

# Configure to make 10 probes per test.

[Sysname-hwping-administrator-dhcp] count 10

# Set the probe timeout time to 5 seconds.

[Sysname-hwping-administrator-dhcp] timeout 5

# Start the test.

[Sysname-hwping-administrator-dhcp] test-enable

# Display test results

[Sysname-hwping-administrator-dhcp] display hwping results administrator dhcp

HWPing entry(admin administrator, tag dhcp) test result:

Send operation times: 10

Receive response times: 10

Table of Contents