3.1.4 Pppoe Quick Setup; Rev. 1 - Yml689 - NetComm NB702 User Manual

3.1.4 PPPoE Quick Setup

QUICK
This command lets you configure a protocol quickly and easily.
Syntax:
R1483(r)/ IPoA(i)/
PPPoA(p)/ PPPoE(pe):
There are a total of 6 PVCs. In the example below 0 PVCs are being used, while 1 is
still available. The prompts from there on are as follows:
Ethernet IP:
Subnet mask:
VPI (0-4095):
VCI (0-65535):
Authentication:
Username:
Password:
Retype Password:
Add another PVC?
Continue Quick?
www.netcomm.com.au
Page 74
quick
Enter "pe" for PPPoE.
Enter the Ethernet IP address.
type in the subnet mask for the IP address.
Enter a VPI value that is between 0 and 4095.
Enter a VCI value that is between 1 and 65535.
Enter PAP, CHAP, or none.
Enter the username received from your ISP.
Enter the password for the username.
Retype the password to confirm the settings.
If you would like to add another PVC, type "y", if
not, type "n" and press "Enter".
You will then see a summary of your configuration.
Preserve the configuration: type "y" to preserve this
configuration, or "n" to ignore it.
Enter "y" if you would like to run another quick
session, or type "n" to continue and save the
changes.

Rev. 1 - YML689

NB702/NB704 User Guide