Software Upgrade; Ix. Software Upgrade - NetComm NB702 User Manual

IX.

Software Upgrade

You may easily upgrade the NB702/NB704 embedded software by obtaining the
compressed upgrade kit from the service provider then following the steps:
■
Extract the ZIP file for updated firmware
■
Connect the NB702/NB704 via the local Ethernet port or remote ADSL link, make
sure that the NB702/NB704 Ethernet IP address and your terminal are properly
configured so that you can successfully "ping" the NB704. The default local IP
address is 192.168.1.1.
■
Under the DOS prompt, execute the command "xupgrade <IP address of NB702/
NB704>", for instance "xupgrade 192.168.1.1".
■
This upgrading process may last as long as 60 seconds.
■
Then reboot the NB702/NB704 with new software.
Rev. 1 - YML689
NB702/NB704 User Guide
www.netcomm.com.au
Page 13