Pat Menu Commands - NetComm NB702 User Manual

2.2

PAT Menu Commands

The following commands are available in Bridge Mode only. To switch between Bridge
and Router mode, use the "mode" command under the main menu.
Command Syntax
Addpatin
Delpatin
Show
ADDPATIN
Add an incoming PAT interface to the PAT table.
Syntax:
Example:
DELPATIN
Add an incoming PAT interface to the PAT table.
Syntax:
Example:
SHOW
Displays the PAT interface table.
Syntax: show
PAT enabled interface:
Interface
No setting
PAT incoming table:
No. i/f name|WanIP
No setting
Rev. 1 - YML689
NB702/NB704 User Guide
Description / Parameters
Pat> addpatin Add incoming PAT table
Pat> delpatin Delete incoming PAT table
Pat> show Show PAT configuration
addpatin bridge <port>[-<port2>]/<udp|tcp|both>
<serverip>
addpatin bridge 80/both 192.168.10.5
delpatin <all>|<number>
delpatin 4
The "4" is the fourth interface in the PAT table. To view the
PAT configuration/table use the "show" command.
IP address
Port/Protocal
www.netcomm.com.au
Server IP
Page 65