Ipoa Menu Commands - NetComm NB702 User Manual

3.2

IPoA Menu Commands

The following commands are available in both bridge and router mode. To switch
between Bridge and Router mode, use the "mode" command under the main menu.
Type "?" followed by ">>" is used retrieve the list of commands to begin the
configuration. Type "home" to return to the main menu.
Command Syntax
Delwanip
Setqos
Setrip
Setwanip
Show
DELWANIP
Delete a WAN IP address from the IPoA table
Syntax:
Example:
Example:
SETQOS
Set the Quality of Service (QoS) for IPOA
Syntax:
Example:
SETRIP
Set the Routing Information Protocol (RIP) for IPOA
Syntax:
Example:
SETWANIP
Set the WAN IP address for IPOA
Syntax:
Example:
www.netcomm.com.au
Page 76
Description / Parameters
>ipoa> delwanip Delete IPoA PVC
>ipoa> setqos Set quality of service (QoS)
>ipoa> setrip Set RIP configuration
>ipoa> setwanip Set IPoA PVC
>ipoa> show Show IPoA configuration
delwanip <all>|[<vpi>/]<vci>
delwanip all
delwanip 8/35
setqos [<vpi>/]<vci> <ubr|cbr|vbr|vbr-rt>
setqos 8/35 ubr
setrip [<vpi>/]<vci> <1|2|1&2|0>
setrip 8/35 2
setwanip [<vpi>/]<vci> [ unnumber | <wanip[/
<masknum>]> <gateway>
setwanip 8/45 unnumber 192.168.2.5
Rev. 1 - YML689
NB702/NB704 User Guide