Ii. Preparation; Chapter 2 - Web Management Interface; Overview; Preparation - NetComm NB702 User Manual

Chapter 2 - Web Management Interface

I.

Overview

The Web management is provided in order to manage NB702/NB704 device as easily
as possible. It provides a very user-friendly configuration and graphical interface
through a web platform. You may configure a bridge or a router function to
accommodate your device need. In the section below, each configuration item will be
described in detail.
II.

Preparation

1. Please refer the hardware installation procedure in Chapter 1 to install NB702/
NB704.
2. You should configure the PC to the same IP subnet as the NB702/NB704.
Example:
NB704: 192.168.1.1
Your PC: 192.168.1.x
3. Connect your PC to NB702/NB704 via an Ethernet cable.
4. Launch the Web browser (IE or Netscape), and enter the default IP address
192.168.1.1 into the address bar to access the web management page.
5. The Enter Network Password dialog box will popup first.
Note1: Some commands or settings shown in this manual may not be available
in the NB702 as it only supports 2 wire SHDSL .
Commands not currently supported in the NB702 are: ipoa, pppoa,
pppoe, rtable.
Note2: You should change the default admin password of your router before you
connect it to the internet or your network.
Note3: When using NAT/PAT a 'Portforward' or 'Incoming Table' entry will be
automatically generated for port 23 (Telnet). This will allow you to log-in
from the WAN side of the NB702/4. If you do not want to allow Telnet
service via the WAN port (Internet) you should delete the table entry for
port 23.
www.netcomm.com.au
Page 14
Rev. 1 - YML689
NB702/NB704 User Guide