Pat Menu Commands - NetComm NB702 User Manual

3.3

PAT Menu Commands

The following commands are available in router mode only. To switch between Bridge
and Router mode, use the "mode" command under the main menu.
Type "?" followed by ">>" is used retrieve the list of commands to begin the
configuration. Type "home" to return to the main menu.
Command Syntax
addpatin
delpatin
setpat
show
ADDPATIN
Add an incoming PAT interface to the PAT table.
Syntax:
Example:
DELPATIN
Add an incoming PAT interface to the PAT table.
Syntax:
Example:
SETPAT
Enable or Disable the PAT function.
Syntax:
Example:
www.netcomm.com.au
Page 78
Description / Parameters
Pat> addpatin Add incoming PAT table
Pat> delpatin Delete incoming PAT table
Pat> setpat Enable or disable PAT function
Pat> show Show PAT configuration
addpatin <pppoa|pppoe|wanip> <port>/<udp|tcp>
<serverip>
addpatin pppoa 80/tcp 192.168.2.5
This will add the PPPoA interface to port 80 using
the TCP protocol to the server 192.168.2.5
delpatin <all>|<number>
delpatin 4
The "4" is the fourth interface in the PAT table. To
view the PAT configuration/table use the "show"
command.
setpat <wanip><(e)nable><(d)isable>
setpat 192.168.2.5 e
This will enable the PAT function on IP address
192.168.2.5
Rev. 1 - YML689
NB702/NB704 User Guide