Basic>Adsl Quick Setup - NetComm NB9 User Giude

Basic>ADSL Quick Setup
The NB9/NB9W can be opened in a Web Browser window of a computer attached to the device by
entering the Web address http://192.168.1.1. Enter User ID: admin and password: admin.
The 'ADSL Quick Setup' page will then be displayed when the device is first started, or if you have
deleted your WAN connection settings or reset the NB9/NB9W to factory defaults. The 'ADSL
Quick Setup' screen appears as follows:
Field
PPPoE Username
PPPoE Password
Save & Connect
Click on Save/Reboot, close the browser window and wait several minutes. Then re-open browser
window and log into NB9/NB9W again following steps above. You will then see the Basic>Home
page indicating your ADSL service is connected. Proceed to configure VoIP and Wireless, if
required.
NOTES:
* PPPoE (Point to Point Protocol over Ethernet) is the standard connection
method for Australian ISPs.
** ADSL is 'UP': this means the ADSL Synch Light must be steady green
If you do not have a PPPoE connection you can click on the link 'Click
Here for Other Connection Types...' which will take you to the page from
where you can select a different connection type.
NB9/NB9W ADSL2+ VoIP Router
YML790 Rev1
Description
The PPPoE username issued by your ISP (e.g.
user@isp.com.au)
The PPPoE password issued by your ISP
This button saves your settings, reboots the NB9/
NB9W and connects to the Internet. Once completed
you will be returned to the 'Status > Diagnostics'
page
25