Router Mode Configuration; Quick Command (Rfc 1483 Bridge) - NetComm NB702 User Manual

3.

Router Mode Configuration

This section lists and describes all the commands that are used for configuring NB702/
NB704 as a router. By default, NB702/NB704 is configured as a bridge.
To switch between Bridge and Router mode, use the "mode" command under the main
menu.
MODE
Switch between bridge and router mode.
Syntax:
>> mode
Please select bridge or router:(b/r,b) b
Current mode is bridge
> >
>> mode
Please select bridge or router:(b/r,b) r
Current mode is router
3.1

Quick Command (RFC 1483 Bridge)

The Quick command allows you to configure four protocols quickly and easily. Each
one is described below.
■
R1483 (Routing)
■
IPoA
■
PPPoA
■
PPPoE
www.netcomm.com.au
Page 68
mode
You will be prompted to choose between a bridge or
router mode. Type "b" for bridge or "r" for router.
The default mode is: bridge
Rev. 1 - YML689
NB702/NB704 User Guide