Chapter 3 - Command Line Interface; Cli Commands - NetComm NB702 User Manual

Chapter 3 - Command Line Interface

I.

CLI Commands

The next few sections in this chapter will describe the commands required to configure
the NB702/NB704 in bridge and router mode. The chapter is divided into three
sections.
1. Main Menu Commands: this section lists all the commands available and
describes the commands that are common in both bridge and router mode.
2. Bridge Mode Configuration: this section lists and describes all the commands
that are used for configuring the NB702/NB704 as a bridge.
3. Router Mode Configuration: this section lists and describes all the commands
that are used for configuring the NB702/NB704 as a router.
Note1: Some commands or settings shown in this manual may not be available
in the NB702 as it only supports 2 wire SHDSL .
Commands not currently supported in the NB702 are; ipoa, pppoa,
pppoe, rtable.
Note2: You should change the default admin password of your router before you
connect it to the internet or your network.
Note3: When using NAT/PAT a 'Portforward' or 'Incoming Table' entry will be
automatically generated for port 23 (Telnet). This will allow you to log-in
from the WAN side of the NB702/4. If you do not want to allow Telnet
service via the WAN port (Internet) you should delete the table entry for
port 23.
Rev. 1 - YML689
NB702/NB704 User Guide
www.netcomm.com.au
Page 51