NetComm NB702 User Manual page 43

3.4.2.1 PAT (Port Address Translation)
To set up PAT (Port Address Translation) click on the PAT link next to the interface
name on the NAT Setup table. You will then see the PAT Incoming Table.
Port:
Protocol:
Server IP:
Click on the Submit button to complete the configuration. You will then notice that
your configuration has been added to the list.
Rev. 1 - YML689
NB702/NB704 User Guide
Enter the port number that you would like to filter.
Select a protocol from the drop down list (TCP or UDP).
Enter the IP address of the server that will receive the
packets.
www.netcomm.com.au
Page 43