Quick Command (Rfc 1483 Bridge) - NetComm NB702 User Manual

2.1

Quick Command (RFC 1483 Bridge)

QUICK
This command lets you configure a protocol quickly and easily.
Syntax:
VPI (0-4095):
VCI (0-65535):
Packet Filter:
Enable Spanning Tree:
Please remember to save and restart the NB702/NB704 in order for the settings to take
affect.
>> quick
1 PVC existed, 7 PVCs available.
VPI(0-4095): 8
VCI(1-65535): 35
Packet Filter ( Any/Ip/Pppoe ): IP
Add another PVC ? (y/n): n
Enable Spanning tree? (y/n) : n
#
1:
Preserve the configuration (y/n) : y
Configuration will have no effect until after save and
restart.
www.netcomm.com.au
Page 64
quick
There are a total of 8 PVCs. In the example below 1 PVC are
being used, while 7 are still available. The prompts from
there on are as follows:
type in a VPI value that is between 0 and 4095.
type in a VCI value that is between 1 and 65535.
(Any/IP/PPPoE) Type in the packet filter you would like to
use.
Add another PVC? If you would like to add another PVC,
type "y", if not, type "n" and press "Enter".
If you would like to enable the Spanning Tree function, type
"y", if not, type "n" and press "Enter".
You will then see a summary of your configuration. Preserve
the configuration: type "y" to preserve this configuration, or
"n" to ignore it.
Configuration
MODE: Bridge
FUNCTION: R1483
Spanning Tree: Disable
VPI VCI
8 35
Package filter
IP
Rev. 1 - YML689
NB702/NB704 User Guide