Table of Contents
Advertisement
6.2 Basic>ADSL Quick Setup
The NB8WVPN can be opened in a Web Browser window of a computer attached to the device by entering the
Web address http://192.168.1.1. Enter User ID: admin and password: admin.
The 'ADSL Quick Setup' page will then be displayed when the device is first started, or if you have deleted your
WAN connection settings or reset the NB8WVPN to factory defaults. The 'ADSL Quick Setup' screen appears
as follows:
Field
User ID
Password
Save & Reboot
Click on Save & Reboot, close the browser window and wait several minutes. Then re-open browser window, if
you are not automatically re-directed, then log into NB8WVPN again following the steps above. You will then see
the Basic > Home page indicating your ADSL service status. Proceed to configure Wireless, if required.
NOTES:
* PPPoE (Point to Point Protocol over Ethernet) is the standard connection method for Australian ISPs.
** ADSL is 'UP': this means the ADSL Sync Light must be steady green
If you do not have a PPPoE connection you can click on the link 'Click Here for Other Connection Types...' which will take you to the page from
where you can select a different connection type.
NB8WVPN User Guide
Description
The PPPoE username issued by your ISP (e.g. user@isp.com.au)
The PPPoE password issued by your ISP
This button saves your settings, reboots the NB8WVPN and connects to the Internet. Once completed you will be
returned to the 'Basic > Home' page
YML8WVPN
www.netcomm.com.au
Advertisement
Table of Contents
