Pppoa Menu Commands - NetComm NB702 User Manual

3.4

PPPoA Menu Commands

The following commands are available in router mode only. To switch between Bridge
and Router mode, use the "mode" command under the main menu.
Type "?" followed by ">>" is used retrieve the list of commands to begin the
configuration. Type "home" to return to the main menu.
Command Syntax
Adduser
Chpass
Connect
Deluser
Disconn
Echo
Setllc
Setqos
Setrip
Show
ADDUSER
Add a user for the PPPoA interface.
Syntax:
Example:
CHPASS
Change the password of the PPPoA interface.
Syntax:
CONNECT
Enable the PPPoA connection.
Syntax:
www.netcomm.com.au
Page 80
Description / Parameters
Pppoa> adduser Add user ID and password
Pppoa> chpass Change user password
Pppoa> connect Pppoa connect
Pppoa> deluser Delete user
Pppoa> disconn PPPoA disconnect
Pppoa> echo Set echo interval time
Pppoa> setllc Add LLC header on the packets
Pppoa> seqos Set class
Pppoa> setrip Set RIP configuration
Pppoa> show Show PPPoA configuration
adduser [<vpi>/]<vci> <userid> [<chap|pap>]
adduser 8/25 john pap
This will add the user john to the 8/25 VPI/VCI
setting with the PAP security setting.
chpass
You will be prompted to enter the old password.
Then enter the new password, and type it again to re-
confirm it.
connect
Rev. 1 - YML689
NB702/NB704 User Guide