Shdsl Menu Commands - NetComm NB702 User Manual

1.4

SHDSL Menu Commands

The following commands are available in both bridge and router mode. To switch
between Bridge and Router mode, use the "mode" command under the main menu.
Type "?" followed by ">>" is used retrieve the list of commands to begin the
configuration. Type "home" to return to the main menu.
Command Syntax
Adapt
Annex
default
Enable
Fix
Status
Terminal
ADAPT
Sets the rate mode.
Syntax:
Example:
ANNEX
Sets annex standard.
Syntax:
Example:
DEFAULT
Sets the SHDSL configurations back to the factory settings.
Syntax:
ENABLE
Activates the last updated SHDSL parameters.
Syntax:
Rev. 1 - YML689
NB702/NB704 User Guide
Description / Parameters
shdsl> adapt Adaptive mode
shdsl> annex SHDSL Standard
shdsl> default Set SHDSL configuration back to factory setting
shdsl> enable Activate the last updated SHDSL parameters
shdsl> fix Fixed mode
shdsl> status Display the configuration and status of SHDSL
setting
shdsl> terminal Configure modem to COE or CPE mode
adapt <maxrate> | <minrate>
adapt 74 (sets adaptive rate to 74. Range is
between 74 and 2312)
annex <a>|<b>|<ab>
annex ab (this will set annex to ab, to verify the annex
value, use the "status" command)
default
enable
www.netcomm.com.au
Page 61