NetComm NB702 User Manual page 33

3.2.1 RFC 1483
Click on the RFC 1483 link on the top of the page. You will then see the RFC 1483
Router Setup table. On this page you can create up to 6 VPI/VCI channels and
configure its QoS, encapsulation, RIP, and WAN IP.
Enable:
VPI:
VCI:
QoS:
RIP:
WAN IP:
Mask:
Click on the Submit button to complete the configuration. You will then see a
confirmation screen.
Rev. 1 - YML689
NB702/NB704 User Guide
Place a check in this box if you would like to enable
the settings in that row.
Enter the VPI value that you received from your ISP.
Enter the VCI value that you received from your ISP.
Select a Quality of Service from the drop down list,
options available are: UBR, CBR, VBR-nrt, VBR –rt.
Select an RIP version from the drop down list,
options available are: none, V1, V2, or V1&V2.
Enter the IP address of the WAN interface.
Enter the subnet mask for the WAN IP.
www.netcomm.com.au
Page 33