3.1.1 R 1483 (Routing) Quick Setup - NetComm NB702 User Manual

3.1.1 R 1483 (Routing) Quick Setup

QUICK
This command lets you configure a protocol quickly and easily.
Syntax:
R1483(r)/ IPoA(i)/
PPPoA(p)/ PPPoE(pe):
There are a total of 6 PVCs. In the example below 0 PVCs are being used, while 6 are
still available. The prompts from there on are as follows:
Ethernet IP:
Subnet mask:
VPI (0-4095):
VCI (0-65535):
WAN IP:
Add another PVC?
Continue Quick?
Rev. 1 - YML689
NB702/NB704 User Guide
quick
Enter "r" for R1483.
Enter the Ethernet IP address.
type in the subnet mask for the IP address.
Enter a VPI value that is between 0 and 4095.
Enter a VCI value that is between 1 and 65535.
Enter the IP address of the WAN interface.
If you would like to add another PVC, type "y", if
not, type "n" and press "Enter".
You will then see a summary of your configuration.
Preserve the configuration: type "y" to preserve this
configuration, or "n" to ignore it.
Enter "y" if you would like to run another quick
session, or type "n" to continue and save the
changes.
www.netcomm.com.au
Page 69