R1483 Menu Commands - NetComm NB702 User Manual

3.5

R1483 Menu Commands

The following commands are available in router mode only. To switch between Bridge
and Router mode, use the "mode" command under the main menu.
Type "?" followed by ">>" is used retrieve the list of commands to begin the
configuration. Type "home" to return to the main menu.
Command Syntax
Delwanip
Setqos
Setrip
Setwanip
Show
DELWANIP
Delete a WAN IP address from the R1483 table.
Syntax:
Example:
Example:
SETQOS
Sets the Quality of Service (QoS) value for VPI and VCI.
Syntax:
Select between:
Example:
SETRIP
Configure the Routing Information Protocol setting.
Syntax:
Example:
Rev. 1 - YML689
NB702/NB704 User Guide
Description / Parameters
R1483> delwanip Delete R1483 PVC
R1483> setqos Set class
R1483> setrip Set RIP configuration
R1483> setwanip Set PVC and Wan IP for routing mode
R1483> show Show RFC1483 configuration
delwanip <all>|[<vpi>/]<vci>
delwanip all
delwanip 8/35
setqos [<vpi>/]<vci> <ubr|cbr|vbr|vbr-rt>
UBR, CBR, VBR, or VBR-rt
setqos 8/35 ubr
setrip <1|2|1&2|0>
Choose between RIP 1, RIP2, RIP 1&2, or 0 (none)
setrip 1
This will set the Routing Information Protocol to
RIP1
www.netcomm.com.au
Page 83