Default Values - NetComm NB702 User Manual

VIII.

Default Values

The NB702/NB704 is pre-configured with the following parameters; you may also re-
load the default parameters by typing Restore in the command line interface. (For
further details, See Chapter 3: Command Line Interface)
Default mode:
User Name:
Password:
Bridge mode setting
Ethernet (local) IP:
Subnet mask:
Full Duplex:
Protocol:
VPI/VCI:
Class (QoS):
Spanning tree:
Packet filter:
G.SHDSL setting
Terminal:
Rate mode:
Annex:
Router mode setting
Ethernet (local) IP:
Subnet mask:
Full Duplex:
DHCP server:
DNS Relay:
Serial Port Properties
Bit per second:
Data bits:
Stop bits:
Parity bits:
Flow Control:
Terminal Emulation:
www.netcomm.com.au
Page 12
Bridge
N/A
admin
192.168.1.1
255.255.255.0
Disable
RFC1483, Bridge Mode
1/32
UBR
Disable
Any
CPE
Adaptive
Annex A
192.168.1.1
255.255.255.0
Disable
Disable
Disable
9600
8
1
None
None
VT100
Rev. 1 - YML689
NB702/NB704 User Guide