Dns Relay Menu Commands - NetComm NB702 User Manual

1.1

DNS Relay Menu Commands

The following commands are available in both bridge and router mode. To switch
between Bridge and Router mode, use the "mode" command under the main menu.
Type "?" followed by ">>" is used retrieve the list of commands to begin the
configuration. Type "home" to return to the main menu.
Command Syntax
?
Setdnsip
Show
SETDNSIP
Sets the IP address for the DNS server.
Syntax:
Example:
SHOW
Sets the IP address for the DNS server.
Syntax:
> dnsrelay> show
Primary DNS Server: 192.168.10.5
Note: Strictly maintain stable power to the NB702/NB704while upgrading its software. If
the power fails during the upgrading process, contents in the memory could be
destroyed, and the system may hang. In such as case, you must call the dealer
or system integrator for repairs.
Rev. 1 - YML689
NB702/NB704 User Guide
> dnsrelay> ?
> dnsrelay> setdnsip
> dnsrelay> show
setdnsip <dnsip> [<retry times>]
setdnsip 192.168.10.5
setdnsip <dnsip> [<retry times>]
Description / Parameters
Lists the commands available under the
current menu
Set the DNS Server IP
Show DNS Relay Configuration
www.netcomm.com.au
Page 57