Connecting Peripheral Devices - NEC EXPRESS5800/120Re-2 Service Manual

Two persons are required when performing the next step.
6. Slowly slide the server out of the rack until the release levers click and lock
the server in place.
Figure 2-33. Removing the Server from the Rack
7. Press in the right and left release levers and carefully slide the server from
the rack.
8. Place the server on a flat stable surface.

Connecting Peripheral Devices

The server is provided with connectors for wide variety of peripheral devices on
its front and rear. Figure 2-34 illustrates available peripheral devices for the
server in the standard configuration and locations of the connectors for the
devices.
Power off the server and peripheral device before
connection. Connecting a powered peripheral device to the
powered server may cause malfunctions and failures.
!
Before connecting a third-party peripheral device or interface cable to the
server, consult with your sales agent. Some third-party devices may not
be used with the server.
!
The total length of a cable (including the connection cable within a SCSI
device) is limited by the SCSI standard. Ask your service representative
for details. (The internal SCSI cable of the server is 0.1 m long.)
!
WARNING
! CAUTION
Setting Up the System 2-27