Table of Contents
Advertisement
Chapter 3 Setup
4. After a while, the following message is displayed on the screen.
Press <F2> to enter setup, <F3> Internal Flash Memory, <F10> Display Boot
Menu , <F12> Force Network Boot
You can call the functions below upon completion of POST by pressing the designated function key.
<F2> key:
<F3> key:
<F10> key: Boot the boot menu.
<F12> key: Boot from network.
5. If you set a password at SETUP in the BIOS Setup utility, the password entry appears upon successful
completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable the server to
boot. In such a case, turn off the power and wait about ten seconds before turning on to boot the server.
6. The OS starts when POST is completed.
POST error messages
If POST detects an error, an error message is displayed on the screen or beeps are sounded. Write down
the error message for future use. For details, see "Maintenance Guide".
104
Run the SETUP. For information on the SETUP, see Chapter 3 (2. System BIOS Setup).
Run
EXPRESSBUILDER
EXPRESSBUILDER, see Chapter 3 (4. EXPRESSBUILDER).
Note
If bootable CD/DVD is inserted into optical disk drive, the system starts from
CD/DVD even if <F3> key is pressed.
Important
Do not set a password before OS is installed.
Express5800/T110j User's Guide
from
Internal
Flash
Memory.
1. Turning on the Server
For
information
on
Advertisement
Table of Contents
