Searching For The Frequency Of The Dcs Used By The Remote Station - Yaesu FT1DR Operating Manual

Using the Tone Squelch Function
Press the M key more than 1 second.
8
The selected DCS code is determined.
Press the M key more than 1 second.
9
The Set mode is canceled.
Hint
• By default, the DCS code is set to "023".

Searching for the Frequency of the DCS Used by the Remote Station

The DCS code used by the remote station can be searched for and displayed.
Press the M key more than 1 second.
1
The Set mode is selected.
Turn the O knob to select "4 SIGNALING".
2
Press the M key briefly.
3
Turn the O knob to select "11 SQL TYPE".
4
Press the M key briefly.
5
Turn the O knob to select "DCS".
6
Press the M key briefly.
7
The selected DCS is determined.
Turn the O knob to select "2 DCS CODE".
8
Press the M key briefly.
9
10
Receive the signal from the remote station.
Press the B key more than about 1 second.
11
"DCS SEARCH" is displayed.
Release the B key.
12
Search for the DCS code starts.
When a coincident DCS code is found, a beep is emitted and search stops
temporarily. The found DCS code blinks.
Hints To set the found DCS code, use the following procedure:
Press the B key.
Press the M key more than 1 second again.
The Set mode is canceled.
Hint
For the operation to perform when scan stops, refer to "Selecting a Reception Method When
Scanning Stops" (See page 57).
72
Press the M key more than 1 second.
A beep is emitted.
FCC ID: K6620445X20
IC: 511B-20445X20
YAESU MUSEN CO., LTD.