Table of Contents
Advertisement
CiM-550 IP Enabled Satellite Modem
Front Panel Menus
4.1.3 L
I
ED
NDICATORS
There are 8 LED indicators. The functions of these indicators are shown in the table
below.
LED
Unit Status
Transmit Traffic
Receive Traffic
On line
Stored Event
Remote
EDMAC Mode
Test Mode
4.1.4 M
T
ENU
REE
The following figures show the menu structure of the CiM-550 front panel menu. The
detailed screens and menus are described in subsequent paragraphs.
Table 4-1. Front Panel LED Indicators
Color
Condition
Red
A Unit Fault exists (Example: PSU fault)
Orange
No Unit Faults, but a Traffic Fault exists
Green
No Unit Faults, or Traffic Faults
Green
No Tx Traffic Faults
Off
A Tx Traffic fault exists OR the Tx Carrier is in OFF state
No Rx Traffic Faults (demod and Viterbi decoder are
Green
locked, everything is OK)
Off
An Rx Traffic fault exists (the demod may still be OK)
Green
The Unit is On Line, and carrying traffic
The Unit is Off Line (standby) - forced by externally
Off
connected 1:1 or 1:N redundancy system
There is a Stored Event in the log, which can be viewed
Orange
from the front panel, or retrieved via the remote control
interface
Off
There are no Stored Events
The Unit is in Remote Mode - local monitoring is possible,
Orange
but no local control
The Unit is in Local Mode - remote monitoring is possible,
Off
but no remote control
Orange
Framing on, EDMAC on, and unit defined as Slave
Either no EDMAC, EDMAC Master, or Transparent mode
Off
is selected
Orange
A Test Mode is selected (Example: IF Loopback)
Off
There is no Test Mode currently selected
23
Rev. 2
CD/CIM550.IOM
Advertisement
Table of Contents
