Comtech EF Data CIM-550 Installation And Operation Manual page 100

CiM-550 IP Enabled Satellite Modem
Remote Control
Parameter Command Arguments for
Command or
Type (Instruction
Response to
Code and
Query
qualifier)
Read N/A 3 bytes
EEPROM
Value
Set RTC DAY= 6 bytes,
numerical
Date
Set RTC TIM= 6 bytes,
numerical
Time
Clear All CAE= None
Stored
Events
Set SSI= 1 byte,
Statistics numerical
Sample
Interval
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
127 starting at address location 104.
(Used for power-level cal, amongst other things)
Query only. FACTORY USE ONLY
A query in the form aaa where aaa is a starting bit
address (in the range 0 - 127) within the modem's
serial EEPROM, requesting that the byte stored at
that location be returned. Example: ERD?063
returns the value of the byte stored at location 063.
(Used for power-level cal, amongst other things)
Command or query
A command in the form ddmmyy, where; dd = day
of the month, between 01 and 31, mm = month of
the year, between 01 and 12 and yy = year,
between 97 and 96 (1997 to 2000, then 2000 to
2096)
Example: DAY=240457 would be April 24, 2057
Command or query
A command in the form hhmmss, indicating the
time from midnight, where hh = hours, between 00
and 23; mm = minutes, between 00 and 59, and ss
= seconds, between 00 and 59
Example: TIM=231259 would be 23 hours, 12
minutes and 59 seconds from midnight.
Command only
Instructs the unit to clear all Stored Events
This command takes no arguments.
Command or Query.
Used to set the sample interval for the Statistics
Logging Function.
74
Response to Command Query
(target to controller)
(Instruction
Code and
qualifier)
N/A ERD?
DAY= (message ok) DAY?
DAY? (received ok,
but invalid arguments found)
DAY* (message ok, but not
permitted in current mode)
TIM= (message ok) TIM?
TIM? (received ok,
but invalid arguments found)
TIM* (message ok, but not
permitted in current mode)
CAE= (message ok) N/A
SSI= (message ok) SSI?
SSI? (received ok,
but invalid arguments found)
Rev. 2
CD/CIM550.IOM
Response to
query
(target to
controller)
ERD=xxx
where xxx is a
value between 0
and 255
DAY=xxxxxx
(same format
as command
arguments)
TIM=xxxxxx
(same format
as command
arguments)
N/A
SSI=x (see
description for
details of
argument)