Comtech EF Data CIM-550 Installation And Operation Manual page 194

CiM-550 IP Enabled Satellite Modem
CLI and Telnet Interface
Menu Options/Fields
Dropped – Filtered
Dropped – Multicast Disable
Group
Dropped – No ARP Entry
Dropped – Bad Buffer
Length
Dropped – Bad IP Version
Dropped – Miscellaneous
Dropped – QOS
Dropped – QOS buffers
Dropped – Dropped buffers
Reset Counters
Save Parameters
Exit
Entry Description
Read Limits certain types of traffic that should not leak to
Only Satellite. For example, broadcasts destined for
Satellite LAN
Read Multicast packet was dropped because, although route
Only existed, IGMP is being used, and there is no client
requesting forwarding of this traffic.
Read The Unicast Packet ARP Fail counter indicates the
Only number of Unicast packets that were received by the
CiM and were destined for a device on the same
subnet as the CiM, but were dropped because the
device specified in the destination IP packet of the
received packet has not yet responded to an ARP.
After power-up, this counter typically increments for the
first three seconds that packets are received for a
device on the same subnet as the CiM.
Read IP length )as specified in packet header) was greater
Only tha payload received in the Ethernet packet. This
would indicate the packet was truncated before
arriving.
The CiM only supports Ipv4. The first four bites of the
Read
Only IP header field (specifies IP Version) are checked.
Catch all bucket for packets experiencing non-
Read
Only standard problems.
Read Packet was dropped because for a particular route
Only (that it matched) the maximum bandwidth has been
exceeded.
Read Packet was dropped because the buffers used to store
Only QOS packets have been exhausted.
Read Packet dropped because the CiM's buffers have
Only exhausted. This will usually occur when the packet
rate through the CiM has exceeded the factory defined
limitiations.
R Executing this menu option resets all statistics
gathered for the receiver to zero.
S This option allows a user to save the current
configuration of the CiM to permanent storage. This
configuration will be restored on each successive
power cycle of the CiM.
X This option allows a user to exit the current menu and
return to its parent menu.
168
Rev. 2
CD/CIM550.IOM