Table of Contents
Advertisement
CiM-550 IP Enabled Satellite Modem
Front Panel Menus
SELECT\CONFIG\MASK\BUF-SLIP
SEL BUF-SLIP ALARM MASK:
ACTIVE MASKED(PRESS ENT)
SELECT\CONFIG\MASK\TX-AIS
SEL TX-AIS ALARM MASK:
ACTIVE MASKED(PRESS ENT)
4.1.5.2.7 SELECT\CONFIG\IMPED
SELECT IF IMPEDANCE:
50 OHMS
4.1.5.3 SELECT\TEST
TEST: NORM
IF
NORM
TX-CW
DISPLAY
DISPLAY
DISPLAY
75 OHMS (ENTER)
DISPLAY
TX-CW TX-1,0
DIG
I/O
RF
(Normal) This clears any test modes or loopbacks, and places the unit
back into an operational state.
(Transmit CW) This is a test mode which forces the modulator to
transmit a pure carrier (unmodulated).
SELECTIONS/DESCRIPTION
ACTIVE - If the user selects ACTIVE, then a
Receive Traffic fault will be generated whenever the
receive circuitry senses that the buffer has either
underflowed, or overflowed.
MASKED - If the user selects MASKED, no alarm
will be generated.
SELECTIONS/DESCRIPTION
ACTIVE - If the user selects ACTIVE, then a
Transmit Traffic fault will be generated whenever
the transmit circuitry senses that the 'all ones'
condition is present in the transmit data.
MASKED - If the user selects MASKED, no alarm
will be generated.
SELECTIONS/DESCRIPTION
50 Ohms
75 Ohms
SELECTIONS/DESCRIPTION
NORM
TX-CW
TX-1,0,
(ENT)
IF LOOP
DIG LOOP
I/O LOOP
41
Rev. 2
CD/CIM550.IOM
Advertisement
Table of Contents
