Table of Contents
Advertisement
CiM-550 IP Enabled Satellite Modem
Remote Control
Parameter
Command
Arguments for
Command or
Type
(Instruction
Response to
Code and
Query
qualifier)
Interval
Clear All
CAS=
None
Stored
Statistics
Retrieve
N/A
75 bytes
next 5
unread
Stored
Events
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
SSI=x, where x = 0 to 9 in 10 minute steps. Note:
setting this parameter to 0 disables the statistics
logging function. Example: SSI=3 means 30
minutes
Command only
Instructs the unit to clear all Stored Statistics
This command takes no arguments.
Query only
Unit returns the oldest 5 Stored Events which have
not yet been read over the remote control. Reply
format: {CR}Sub-body{CR}Sub-body{CR}Sub-
body{CR}Sub-body{CR}Sub-body, where Sub-
body=
ABCddmmyyhhmmss,
A being the fault/clear indicator.
F=Fault
C=Clear
I=Info
B being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Power on/off, or log cleared
and C being the fault code, as defined under the
'FLT' message table entry, except Info codes,
which are: 0=power off, 1=power on, 2=log
cleared, 3=global config change, and 4=
redundancy config change. If there are no new
events, the unit replies with RNE? If there are less
75
Response to Command
Query
(target to controller)
(Instruction
Code and
qualifier)
SSI* (message ok, but not
permitted in current mode)
CAS= (message ok)
N/A
N/A
RNE?
Rev. 2
CD/CIM550.IOM
Response to
query
(target to
controller)
argument)
N/A
RNE={CR}ABC
ddmmyyhhmms
s{CR}ABCddm
myyhhmmss{C
R}ABCddmmyy
hhmmss{CR}AB
Cddmmyyhhmm
ss{CR}ABCddm
myyhhmmss
(see description
for details of
arguments)
Advertisement
Table of Contents
