Comtech EF Data CIM-550 Installation And Operation Manual page 92

CiM-550 IP Enabled Satellite Modem
Remote Control
Parameter Command Arguments for
Command or
Type (Instruction
Response to
Code and
Query
qualifier)
Rx RDS= 1 byte, value of
0 or 1
Descrambler
Rx Demod RSW= 2 bytes,
Acq Sweep numerical
Width
Rx Clock RCK= 1 byte, value of
Mode 0 or 1
Eb/No Alarm EBA= 4 bytes,
Point numerical
Rx Buffer RBS= 1 byte, value of
Size 1,2,3,4 or 5
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
0 = Normal
1 = Rx Spectrum Inverted
All other codes invalid.
Command or Query.
Rx De-scrambler state, where:
0 = Off
1 = On (V.35 in unframed mode, synchronous in
framed mode
All other codes invalid.
Example: RDS=1 (which is de-scrambler On)
Command or Query.
Rx ± acquisition sweep range of demodulator, in
kHz, ranging from ± 1 kHz to ± 30 kHz.
Example: RSW=09 (which is 9 kHz)
Command or Query.
Rx Clock mode, where:
0 = Buffer disabled
1 = Buffer enabled
All other codes invalid.
Example: RCK=0 (which is buffer disable)
Command or Query.
Eb/No alarm point, with a range of Eb/No between
0 and 16 dB. Resolution 0.1 dB.
Example: EBA=12.3 (which is Eb/No = 12.3 dB)
Command or Query.
Rx buffer size, where:
66
Response to Command Query
(target to controller)
(Instruction
Code and
qualifier)
but invalid argument found)
RSI* (message ok, but not
permitted in current mode)
RDS= (message ok) RDS?
RDS? (received ok,
but invalid argument found)
RDS* (message ok, but not
permitted in current mode)
RSW= (message ok) RSW?
RSW? (received ok,
but invalid arguments found)
RSW* (message ok, but not
permitted in current mode)
RCK= (message ok) RCK?
RCK? (received ok,
but invalid argument found)
RCK* (message ok, but not
permitted in current mode)
EBA= (message ok) EBA?
EBA? (received ok,
but invalid arguments found)
RBS= (message ok) RBS?
RBS? (received ok,
Rev. 2
CD/CIM550.IOM
Response to
query
(target to
controller)
argument)
RDS=x
(same format as
command
argument)
RSW=xx
(same format as
command
arguments)
RCK=x
(same format as
command
argument)
EBA=xx.x
(same format as
command
arguments)
RBS=x
(same format as