Comtech EF Data CIM-550 Installation And Operation Manual page 98

CiM-550 IP Enabled Satellite Modem
Remote Control
Parameter Command Arguments for
Command or
Type (Instruction
Response to
Code and
Query
qualifier)
Config Store CST= 1 byte,
numerical, 0 to
9
Config Load CLD= 1 byte,
numerical, 0 to
9
Re-center RCB= None
Buffer
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
B= AUPC enable - same as AUP= (1 byte)
Y = AUPC setup - same as APP= (6 bytes)
W =Stats log interval- same as SSI (1 byte),
Example:
MGC=074.56780064.0001720112.720082.65430
128.0002320116109.81211100000102361115.659
Forces the unit to store the current modem
configuration in Configuration Memory location
defined by the one byte argument (0 to 9).
Example CST=4 (Store current config in location 4)
WARNING: Use with caution! If the location
already contains data it will be automatically
overwritten. If in doubt, query the location first.
Command only.
Forces the unit to retrieve the Configuration
Memory location defined by the one byte argument
(0 to 9). and to re-program the unit with that stored
configuration.
Command only.
Forces the unit to re-center the receive
plesiochronous/doppler buffer.
72
Response to Command Query
(target to controller)
(Instruction
Code and
qualifier)
CST= (message ok) CST?n, where
CST? (received ok, but n is 0 to 9
invalid arguments found)
CST?0, or
CST?1, or
CST?2, or
CST?3, or
CST?4, or
CST?5, or
CST?6, or
CST?7, or
CST?8, or
CST?9
CLD= (message ok) N/A
CLD? (message received
ok, but an invalid argument
was found,
CST* (message ok, but the
requested location does not
contain a valid configuration)
RCB= (message ok) N/A
Rev. 2
CD/CIM550.IOM
Response to
query
(target to
controller)
Return the
same format as
the MGC with
the form:
CST= for a
valid config, and
CST* where no
valid config is
found in that n
N/A
N/A