Pc Coniguration - Comtech EF Data CIM-550 Installation And Operation Manual

CiM-550 IP Enabled Satellite Modem
CiM IP Module Checkout & Fault Isolation
14.2.1 E
QUIPMENT
Following equipment is required:
Item Equipment
1 CiM-550 Modem
2 10/100baseT Ethernet Hub
3 PC with NIC and a terminal
emulation program
4 Console cable (DB-9 to RJ-11)
5 Ethernet cables
6 IF cables
7 Traffic Generator such as
SmartBits
14.2.1 E
QUIPMENT
Step Procedure
1 Connect each CiM to the PC via the Ethernet Hub.
2 Connect the TX IF on CiM 1 to RX IF of CiM 2 and vice-versa.
3 Connect the DB-9 end of the console cable to the COM1 or COM2 port of the PC and
the RJ-11 end to the console port at the back of CiM 1.
4 Connect CiM 1 and CiM 2 to suitable power supply and turn them ON.
14.2.2 PC C
ONIGURATION
Step Procedure
1 Set the IP address on PC 1 to 172.16.10.100, mask to 255.255.255.0 and gateway to
172.16.10.10.
2 Set the IP address on PC 2 to 172.17.10.100, mask to 255.255.255.0 and gateway to
172.17.10.10.
Reboot the PCs (if required).
L
IST
Optional Equipment
S
ETUP
Quantity Comments
2
2 Provided by customer
2 Provided by customer
1 Can be procured from Comtech EF Data
4 Provided by customer
2 Provided by customer
(For IF loopback only. Additional
equipment required for RF connectivity.)
1 Provided by customer
420
Rev. 2
CD/CIM550.IOM