Table of Contents
Advertisement
CiM-550 IP Enabled Satellite Modem
SNMP interface
13.5.1.7 S
P
TATUS
OID
cim550RxEbno
cim550RxCoarseAGC
cim550RxFrequencyOffset
cim550BufferFillState
cim550RxBER
cim550RedundancyState
cim550ModemUnitFaults
ARAMETERS
Table 13-42. Status Parameter OIDs
Description
Value of Ebi/No, can be between 0 and 160 in 0.1 dB
where 0 = 0.0 dB to 160 = 16.0 dB and 999 = Demod
Unlocked
Vaue of Coarse AGC setting, can be between 0 and 99.
Value of frequency offset of the carrier being
demodulated. Can be between -30 KHz and 30 KHz
where -30 = -30 KHz to 30=+30 KHz and 999 = Demod
Unlock.
Value of the buffer fill state. Can be between 0 and 99 in
percentage filled.
Value of the estimated corrected bit error rate. Value has
-10
been multiplied by 10E
Returns the redundancy state of the unit, where: 0 = Off
Line (forced into standby by 1:N or 1:1 Switch) 1= On
Line (normal). Valid values are:
0
Offline
1
Online
Returns the current fault and status codes for the Unit
(hardware). The value will be a integer between 0 and
8191 where the bit that is set indicates which fault has
occurred:
bit 0
not used, always 0
bit 1
volt power supply
bit 2
12 volt power supply
bit 3
5 volt power supply
bit 4
18 volt power supply
bit 5
12 volt power supply
bit 6
RAM load fail
bit 7
Tx synthesizer unlocked
bit 8
Rx synthesizer unlocked
bit 9
Power cal checksum fail
bit 10
FPGA main chain load fail
bit 11
Turbo FPGA load fail
bit 12
IP Module fail
253
CD/CIM550.IOM
.
Rev. 2
Advertisement
Table of Contents
