Table of Contents
Advertisement
CiM-550 IP Enabled Satellite Modem
CiM IP Module Checkout & Fault Isolation
14.2.3 T
RANSMIT AND
Step
Procedure
Configure the transmit and receive IF parameters on CiM 1 and CiM 2 via the front panel.
1
Note: The IF parameters can also be set via console menu, Telnet, web interface and SNMP -
but for this exercise, it is recommended that the front panel be used.
2
Set the TxPower to minimum level.
3
Before proceeding to next step, make sure that each CiM is locked to the other CiM.
14.2.4 B
IP C
ASIC
Step
Procedure
1
Launch the terminal emulation program - such as HyperTerminal on Microsoft Windows.
Select the appropriate COM port (to which the DB-9 end of the console cable is
2
connected) and configure it for:
38,400 bps
8 data bits
no parity
1 stop bit
no hardware flow control
3
Press return and to bring up the Main menu.
R
IF C
ECEIVE
ONFIGURATION
ONFIGURATION
421
Rev. 2
CD/CIM550.IOM
Advertisement
Table of Contents
