Comtech EF Data CIM-550 Installation And Operation Manual page 95

CiM-550 IP Enabled Satellite Modem
Remote Control
Parameter Command Arguments for
Command or
Type (Instruction
Response to
Code and
Query
qualifier)
Circuit ID CID= 24 bytes,
string
ASCII
Outdoor Unit ODU= 1 byte, value of
Comms 0 or 1
AUPC AUP= 1 byte, value of
0 or 1
Enable
AUPC APP= 6 bytes,
Parameters
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
define the unit as being an EDMAC Master.
This command is only valid for an EDMAC master.
When used as a Query, it may be sent to an
EDMAC slave, which will respond with the
appropriate address.
Command or Query.
Sets or queries the user-defined Circuit ID string,
which is a fixed length of 24 characters.
Valid characters include:
Space ( ) * + - , . / 0-9 and A-Z.
Command or Query.
Enables or disables communication, via an FSK
serial link, with a Comtech Transceiver (Outdoor
unit).
0 = disabled
1 = enabled
Example: ODU=0
Command or Query.
Enables or disables AUPC (Automatic Uplink
Power Control). 0 = disabled 1 = enabled
Example: APC=0
Note: Framing must be selected for the AUPC
feature to work. If AUPC is selected when Framing
is disabled, APC* will be returned
Command or Query.
Defines AUPC (Automatic Uplink Power Control)
operating parameters. Has the form abc.cd
Where:
a = Define action on max power condition:
69
Response to Command Query
(target to controller)
(Instruction
Code and
qualifier)
CID= (message ok) CID?
CID? (received ok,
but invalid arguments found)
ODU= (message ok) ODU?
ODU? (received ok,
but invalid arguments found)
ODU* (message ok, but not
permitted in current mode)
AUP= (message ok) AUP?
AUP? (received ok,
but invalid arguments found)
AUP* (message ok, but not
permitted in current mode)
APP= (message ok) APP?
APP? (received ok,
but invalid arguments found)
APP* (message ok, but not
permitted in current mode)
Rev. 2
CD/CIM550.IOM
Response to
query
(target to
controller)
CID=xxxxxxxx
xxxxxxxxxxxxxx
x (same format
as command
arguments)
ODU=x
(same format as
command
arguments)
AUP=x
(same format as
command
arguments)
APP=abc.cd
(same format as
command
arguments)