Table of Contents
Advertisement
CiM-550 IP Enabled Satellite Modem
Remote Control
Parameter
Command
Arguments for
Command or
Type
(Instruction
Response to
Code and
Query
qualifier)
Local/Remot
LRS=
1 byte, value of
e Status
0 or 1
Serial
SNO=
4 bytes
Number
numerical
0000 to 9999
Software
N/A
4 bytes,
Revision
numerical
Equipment
N/A
6 bytes,
ID
numerical
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
0 = Off Line (forced into standby by 1:N or 1:1
Switch) 1= On Line (normal). All other codes
invalid. Example: RED=1 (On Line)
Command or query (Command only if S/W > 1.13)
As a query, returns the local/remote status of the
unit, where:
0 = local
1= remote
When used as a comand, uses the same codes for
an argument.
Example: LRS=1 (unit is in remote mode)
Command portion is FACTORY USE ONLY. Used
to set or Query the units 4 digit serial number.
Unit returns its S/N, in the form xxxx.
Example: SNO=1765
Query only.
Unit returns the value of internal software revision
installed in the unit, in the form x.xx
Example: SWR=1.03 (Ver 1.03)
Query only.
Unit returns the equipment identification, and the
options fitted, in the form aaaabc, where:
aaaa defines the Modem model number. Example:
2550 is CiM-550, no Reed-Solomon or Turbo 3550
is CiM-550 with Reed-Solomon Codec
4550 is CiM-550 with Turbo Codec fitted (Rate 3/4
QPSK only - S/W Version less than 1.15)
5550 is CiM-550 with Turbo Codec fitted (Rate 3/4
QPSK, plus Rate 21/44 and Rate 5/16 BPSK)
78
Response to Command
Query
(target to controller)
(Instruction
Code and
qualifier)
LRS=
LRS?
(message ok)
SNO= (message ok)
SNO?
N/A
SWR?
N/A
EID?
Rev. 2
CD/CIM550.IOM
Response to
query
(target to
controller)
arguments)
LRS=x (see
description for
details of
arguments)
SNO=xxxx (see
description for
details of
arguments)
SWR=x.xx (see
description for
details of
arguments)
EID=aaaabc
(see description
for details of
arguments)
Advertisement
Table of Contents
