Use The Base Modem Http Interface To Find The Firmware Information; Make A Temporary Folder (Subdirectory) On The User Pc - Comtech EF Data SLM-5650A Installation And Operation Manual

5.2.3.4 Use the Base Modem HTTP Interface to Find the Firmware
Information
Do these steps:
Step
1 The 'Firmware Information' section of the 'Maint | Unit Info' page provides the Firmware Information
details as Boot, Bulk1, and Bulk2 as shown in this example:
2 Write down your firmware information for further reference or to provide to Comtech EF Data
Product support.
5.2.4

Make a Temporary Folder (Subdirectory) on the User PC

The temporary folder is where you store the firmware archive download. There are several ways
you can make a temporary folder on a Windows PC:
•
To use the Windows Desktop, see Section 5.2.4.1.
•
To use Windows Explorer, see Section 5.2.4.2.
•
To use the Run and Browse windows, see Section 5.2.4.3.
•
To use Windows Command-line or the Command Prompt, see Section 5.2.4.4.
After you make the temporary folder, proceed to Section 5.2.5 to download and extract the
firmware files.
These examples specify drive letter "c:". You can use any valid, writable drive
letter.
Typical for many of the tasks that follow, type the command as instructed and
then press Enter.
Firmware Update
Task
5–6
SLM-5650A Satellite Modem
Revision 10
MN-SLM-5650A