Fw/Bk Act; Ribbon Save; Head Up Cut/Rwd - Toshiba B-EX6T Series Key Operation Specification

9.5.4 FW/BK ACT.

・ MODE1: Normal:
・ MODE2: SHORT CUT LAB: When the thermal transfer method and cut issue are selected, the printer
・ MODE3: for RFID:
Notes:
1. When MODE2 is selected and the printer starts printing (feed) from the forwarded position, it feeds the
media for 3 mm from this position and temporarily stops. The feed speed for this 3-mm distance to the
home position is the max. speed that can be accelerated from the previous speed (See the following).
After the temporary stop, the printer prints or feeds the media at the specified speed.
B-EX6T1/T3
B-EX6T1/T3
B-EX4T1
B-EX4T1
* Except for the multi-step acceleration area for short-pitch labels, the print speed will be accelerated up to
the specified speed when the media has not been forwarded.
2. When MODE3 is selected and the RBN SAVE parameter is set to "LABEL" or "TAG", the printer will raise
the print head while the auto feed to the cut/strip position is performed.
If labels with the pitch of 57.2mm or less are used, they may peel off from the backing paper. Therefore, it
is required to select "LABEL" or "TAG" for the RBN SAVE parameter. The speed of the auto feed is fixed
to 3 ips.

9.5.5 RIBBON SAVE

B-EX6T1/T3
・ OFF
・ POSITION1
・ POSITION2
B-EX4T1
・ OFF
・ TAG POSITION
・ LABEL POSITION
Notes:
1. If this parameter is set to "POSITION1(TAG POSITION)" or "POSITION2(LABEL POSITION)" without
the ribbon saving module installed, the ribbon slacks and a print failure occurs. Caution required when
setting this parameter.
2. For B-EX6T1, only Position1 is available to use since there is no distinguish between TAG and LABEL.
3. If the actual lock position of the head opening / closing lever and the setting contents of this parameter
do not match, the ribbon save function may not operate normally.

9.5.6 HEAD UP CUT/RWD.

The printer waits for a next issue after media is forwarded fixed length.
B-EX6T1/T3:
B-EX4T1:
feeds 6-mm media backward, then waits for next issue with media forwarded
3-mm.
The printer waits for a next issued after media is forwarded fixed length (to
prevent RFID media jam.)
B-EX6T1/T3:
B-EX4T1:
203-dpi model: 5 ips
305-dpi model: 5 ips
203-dpi model: 6 ips
305-dpi model: 5 ips
The ribbon saving module is not used.
The ribbon saving module is used.(Head lever position: "Position1")
The ribbon saving module is used.(Head lever position: "Position2")
The ribbon saving module is not used.
The ribbon saving module is used.(Head lever position: "TAG")
The ribbon saving module is used.(Head lever position: "LABEL")
16.5mm
13.7mm
34.0mm
31.2mm
80